Soqi Quick Spring Adjuster - Installation Instructions

Remove the shock(s) from the sled that the adjuster(s) will be installed on. When removing the center shock the limiter strap may need to be loosened. Remove both of the of the spring retainer rings. Put a light coat of grease on the shock body threads. Put grease on each side of the thrust bearing, put a thrust bearing washer on each side of the bearing and place them into the adjuster pocket. Screw the adjuster onto the shock body and set the spring height back to the desired setting. Install the shock into the sled. On ski shocks install the shocks with the nitrogen valves to the top facing in, on the center shock install the nitrogen valve to the top facing down (forward) toward the cross shaft of the front arm. Tighten limiter.

INSTALLED SPRING LENGTH: SKI SHOCKS, 10 1/8” (short track), 8 ¾” MOUNTAIN -  CENTER SHOCK, 7 ½” STANDARD